Computronix Logo


September 29, 2009 New Product Release …. Mighty-Module II™

Compu-Tronix announces the first points replacement module with True Linear Dwell control. The Mighty Module II™, when used with the Compu-Tronix RX-2, 0.5 Ohm coil, produces 80 millijoules of spark energy and 60,000 open circuit Volts! It produces more than twice the energy of any competitive module and more energy than most electronic ignition systems with bulky, external electronics boxes. It delivers 100% energy over the entire operating rpm range with absolutely no fall off at high rpm. It has the same ease of installation as the standard Mighty-Module.

September 26, 2009 “Crusin For A Cure™” Trade Show

Compu-Tronix displays the DIS8 Distributorless Ignition Product Line at the world’s largest one day charity car show benefiting Prostrate Cancer. Over 3,000 Hot Rods, Street Rods, Muscle Cars, Street Machines and Trucks were on display.

August 18, 2009 New Product Release … Optional, Internal REV Limiters for DIS4 and DIS6 Single and Dual, Distributorless Ignition Models.

Compu-Tronix announces the availability of optional, Internal REV Limiters for DIS4 and DIS6, Single and Dual Distributorless Ignition Models. The Safe Guard™ REV Limiter controls the spark train internally, at the logic level, and can not cause a mistimed spark. External rpm limiters, that control the spark train at the power level, can cause mistimed sparks which, in turn, cause pre-ignition. This can cause pre-mature engine failure.

June 10, 2009 New Product Release … Dual Ignition DIS4 and DIS6 Models.

Compu-Tronix announces the availability of Dual Ignition DIS 4 and DIS6 Models. They have the same easy installation as standard DIS Models. All electronics are housed in a single, American made, precision CNC machined billet aluminum housing. These are the highest performance ignition systems available for 4 and 6 cylinder engines bar none! Initial models are available for Ford 2.3L, Porsche carbureted 911s and 4 cylinder VWs and Porsches.

February 12, 2009 New Product Release … American Made, CNC Distributors for DIS4, DIS6 and DIS8 Models

Compu-Tronix announces that all DIS Ignition Systems now come completely factory assembled with our own ultra high quality, American made, precision CNC machined distributor housings. Compu-Tronix determined that low quality imported and remanufactured distributor bodies were compromising the performance of the DIS Ignition Systems. This situation has been eliminated with the highest quality distributor housings in the industry.

December 10, 2008 PRI Show

Plan to visit the Compu-Tronix Ignition Systems booth at the 2008 SEMA Show in Las Vegas, NV. Nov. 4-7, Booth # 21767 at the Las Vegas Convention Center.

November 4, 2008 SEMA Show

Compu-Tronix introduces the industry’s first “clip on” Distributorless Ignition Systems at the 2008 SEMA Show.

August 8, 2008 … New Product Release … Industry’s First “Clip On” Distributorless Ignition Module

Compu-Tronix announces the industry’s first “clip on” Distributorless Ignition Modules with True Linear Dwell Control. All electronics are housed in a billet aluminum cap that simply “clips on” to the existing distributor body. There is no external electronics box. Distributorless Ignition is now easier to install than other manufacturer’s single coil systems! These systems are the highest performance ignition systems available in the industry, completely maintenance free.

June 5, 2008 New Product Release … Mighty Module™

Compu-Tronix announces the Mighty Module™ Points Replacement Electronic Module for the VW 009 Distributor. Longer dwell produces quicker starting, higher performance at high rpm and better fuel economy. Ignition maintenance is reduced to a bare minimum. The Mighty Module™ is compatible with stock and high performance ignition coils. Easy installation requires no hardware and is a simple two wire hookup.